GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » PANDA » PandaRoot » Bugs, Fixes, Releases » Question about geometryversion for EMC
Re: Question about geometryversion for EMC [message #11945 is a reply to message #11793] Thu, 02 June 2011 06:38 Go to previous messageGo to previous message
Dmitry Morozov is currently offline  Dmitry Morozov
Messages: 34
Registered: May 2007
Location: Protvino, Russia
continuous participant
 From: 194.190.166*
Hello,

I have tested the full sim with version 17 of EMC geometry (FSC included).

The macros I used tdrct/run_sim_tpccombi_dpm.C and run_digi_tpccombi.C. Number of event 10k, momentum 5 GeV.

sim macro run smoothly without any problem, and results looks reasonable. So, no problems from FSC side. I think you can return it to business.

digi macro have eaten 4GB of RAM plus ~4GB of swap, but PC survived and macro has finished. I believe this memory consumption is due to TPC digi procedure.

My PC is ubuntu 11.04 64 bit, "may11" externals and rev. 12075 of pandaroot.

Best regards,
Dmitry

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Reconstruction macro crush - PndMCTrackAssociator
Next Topic: Dart.sh ncpu issue
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Sep 10 08:37:38 CEST 2026

Total time taken to generate the page: 0.00882 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software