GSI Forum: General » Errors in Running Manual Segmentation Macro for SIS-100 New Geometry

Home » CBM » CBMROOT » General » Errors in Running Manual Segmentation Macro for SIS-100 New Geometry

Show: Today's Messages :: Polls :: Message Navigator

Errors in Running Manual Segmentation Macro for SIS-100 New Geometry [message #10420]

Wed, 17 March 2010 13:25

Buddhadeb Bhattacharjee
Messages: 5
Registered: March 2008
Location: Guwahati, India

occasional visitor

From: 59.99.48*

Dear All,
While running manual segmentation macro, i've encountered an error that i couldn't sort out. The no. of sectors and pads are shown 'zero' and also the minimum sector size and minimum pad size are shown abnormally large. Attached .tar file contains the error messages and all the relevant macros and classes that i have been using for the purpose. Can any one help me out in fixing the problem?
Thanks in anticipation.

Attachment: error_GU_in.tar
(Size: 360.00KB, Downloaded 444 times)

[Updated on: Wed, 17 March 2010 13:39]

Report message to a moderator

Re: Errors in Running Manual Segmentation Macro for SIS-100 New Geometry [message #10422 is a reply to message #10420]

Wed, 17 March 2010 15:22

Mikhail Ryzhinskiy
Messages: 60
Registered: December 2006
Location: St.-Petersburg, Russia

continuous participant

From: 140.181.9*

Dear Buddhadeb,

I tested your geometry and segmentation with the TRUNK version of CBMROOT. Stations were segmented without any error. The CbmMuchSegmentManual.cxx file you attached is the old one. Thus, you need to make an update.

With best regards,
Misha.

Report message to a moderator

Previous Topic:	New external packages July 09
Next Topic:	RuleChecker

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 24 07:41:04 CET 2024

Total time taken to generate the page: 0.00675 seconds